1. The red warning indicates an error in the 48-volt power supply.
2. Park the vehicle in a safe place.
3. Stop the engine and turn off the ignition.
4. Wait a few seconds, switch the ignition back on, and start the engine.
5. If the lamp remains on, seek professional assistance; SEAT recommends visiting a SEAT dealership.

With the ignition on, engine off, and vehicle stationary, select Vehicle > Vehicle status > Service in the infotainment system.

A red brake-fluid warning light means the level is too low: stop driving, check the level, and seek specialist assistance if it is too low.

Check that the brake fluid is between the markings; if it drops noticeably in a short time or below the mark, seek specialist assistance because there may be a leak.

Unlock the vehicle in darkness with the automatic dipped beam function enabled; the light turns off after its delay or when you lock the vehicle.

Switch off the ignition in darkness with automatic headlight control enabled; the light starts after the last door or rear lid closes and ends after the delay, if a door stays open 30 seconds, or when you switch on the ignition.

If the ABS indicator lamp stays on or comes on while driving, ABS may be unavailable; go to a specialized workshop as soon as possible.

If the yellow ESC control lamp remains on, the ESC has been switched off because of a fault.

Turn the ignition off and on again; if possible, drive briefly at 15-20 km/h (9-12 mph), then visit a specialized workshop if the lamp stays on.

The manual does not list a separate spark-plug interval; spark plugs can be changed when the corresponding oil-change or inspection service is due.

These intervals assume normal use, while adverse conditions may require service before the next interval or between intervals.

Replace the dust and pollen filter regularly to maintain air-conditioning performance, and more often than the Service Schedule states in highly polluted areas.

The key left inside is blocked when the vehicle is locked from outside with another key; press its button to reactivate it for starting.